Mini Nano V3.0 ATmega328P Microcontroller Board w/USB Cable for Arduino

Description

Note: Before running the procedure, pls install the corresponding computer system driver.

Drivers: directly from the chip manufacturer:

WCH 340 product home page:

http://www.wch.cn/product/CH340.html

http://www.wch.cn/download/CH341SER_LINUX_ZIP.html (linux should operate fine without the driver)

http://www.wch.cn/download/CH341SER_MAC_ZIP.html

http://www.wch-ic.com/download/list.asp?id=127 (windows)

http://bit.ly/2pMF4in

ATmega328 Microcontroller
Microcontroller ATmega328P-AU
Fully Compatible to Arduino Nano V3.0 ATmega328P-AU
Input Voltage (recommended) 7V-12V;Input Voltage (limits) 6V-20V
Bootloader installed, ready to upload sketches from Arduino software
Analog Input Pins 8
Operating Voltage 5V
DC Current per I/O Pin 40 mA
DC Current for 3.3V Pin 50 mA
Digital I/O Pins 14 (of which 6 provide PWM output)
Flash Memory 32 KB (ATmega328) of which 2 KB used by bootloader
SRAM 2 KB
EEPROM 1 KB
Clock Speed 16 MHz
Cable Length:245mm
Dimention:Approx. 45x17x19mm
Color:Blue(as the picture shows)

Package:
1 x Nano V3.0 ATmega328P Arduino Compatible Board
1 x Mini USB Cable

Make sure this fits by entering your model number.
Attention:before running the procedure, pls install the corresponding computer system driver. Drivers: directly from the chip manufacturer: WCH 340 product home page: http://www.wch.cn/product/CH340.html; http://www.wch.cn/download/CH341SER_LINUX_ZIP.html (linux should operate fine without the driver); http://www.wch.cn/download/CH341SER_MAC_ZIP.html; http://www.wch-ic.com/download/list.asp?id=127 (windows); http://bit.ly/2pMF4in.
If you need an older driver, pls get it from GitHub—please read the link that follows immediate. http://sparks.gogo.co.nz/ch340.html; More detals on how to use it please refer to: http://audiodiwhy.blogspot.com/2018/05/one-cheap-arduino-nano-clone-o-plus-one.html
Small Arduino UNO Board:It is a smallest, complete and breadboard friendly board. It has everything that Arduino/Genuino UNO has (electrically) with more analog input pins and onboard +5V AREF jumper.More Breadboard Space:Nano’s got the breadboard-ability of the Boarduino and the Mini+USB with smaller footprint than either, so users have more breadboard space. It’s got a pin layout that works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other).
Specification:The Nano can be powered via the Mini-B USB connection, 7-12V unregulated external power supply (pin 30), or 5V regulated external power supply (pin 27). The power source is automatically selected to the highest voltage source.Usage: The Nano is 100% compatible with Arduino, with the same chips ATmega328P and CH340 with the official version.